Roof Supports Run Parallel To The Ridge

Essentially the spine of a conventional stick framed roof the ridge board is sandwiched between the meeting ends of the roof rafters.

Roof supports run parallel to the ridge.

Position the square with the base or raised edge on top of the rafter board. The ridge is the horizontal peak of the roof. The existing ridge board might serve as a ridge beam if adequate supports can be installed such as a wall or closely spaced columns. Some of these can support the roof and prevent ridge sagging and wall spreading.

Rafters are sloped beams that run from the roof s ridge to the eaves. The ridge is the peak where two sloped roof sections meet. Mark the plumb line for the ridge line cut near the end of the rafter board. Collar ties rafter ties tension beams structural ridge beams.

The shingle should be in the center of the ridge. Line up the edges with the chalk line and secure with 2 roof nails right above the adhesive line on the shingle tab. The venting in the roof should never be cut all the way to the edge but that doesn t mean you can t install the vent cap all the way to the edge. A purlin is a horizontal piece of timber or metal which supports the roof s rafters or decking and helps to prevent your roof from sagging.

Continue along the ridge of the roof until you have all of the shingles secured. In the case of the perpendicular gable the roof rafters are parallel to the wall the rafters that form the wall side gable are flush against the wall and the ridge board at the peak of the roof. We cut the vent in the roof decking sheathing to within a foot or 2 of the edge and always install shingle vent 2 right to the edge because most people think it s a cleaner look. This article describes and illustrates the different types of support that prevents roof sagging and wall bulging at buildings including definitions of collar ties rafter ties and structural ridge beams.

Part of a roof s frame a ridge board runs horizontally along the peak of a sloped roof. Start at one of the eaves of the ridge and wrap a shingle around the ridge of the roof.