Step 2 position pocket door pull.
Pocket door edge pull installation.
You just need a few tools to do the job right.
This is a door pull for a pocket this is a door pull for a pocket door in satin nickel.
These are designed to fit pocket doors from 1 3 8 in.
These edge pulls are most commonly used on pocket doors that when completely open are flush with the door jamb.
The finger pull is used to pull the door out of its pocket.
Door pulls are installed on the edge of the door that work with a touch.
Step 3 mark the screw points.
How to install a pocket door pull.
This product can expose you to lead which is known to the state of california to cause cancer and birth defects or other reproductive harm for more information go to p65warnings ca gov.
Insert the pocket door pull assembly into the notch until the edge face of the pull is flush with the surface of the door edge.
Mark the spots for the mounting screws using an awl.
Position the pocket door pull on the edge of the door backwards and mark the center using a carpenter s pencil.
Drill the mounting screw holes.
Pocket door edge pull are a popular type of door closets and bathrooms.
The final step in completing a pocket door installation of door pull which consists of a color edge stick to pull the door out of his pocket and finger grooves on each side used to push the door closed.
To 1 3 4 in.
Installing an emtek 2221 edge pull is a pretty simple process.
Trace the lever outline on the door s edge.
First you will want to mark the bottom of where you will wan the finger pull mounted in our case we are mounting the pull below the pocket door lock that was already installed in the door.
Pocket doors slide completely into a compartment in the wall with only the edge showing.
Narrow design eliminates installation problems on thin door conditions.
After you have it marked center your edge pull on the door edge by using your measuring tape if needed.
The pull lever should pivot from the top.
Secure the pull to the door with the wood screws provided.
More product details close.
Step 4 drill holes.
Non handed design for left or right handed doors.